Afin de vous proposer des services et offres adaptés à vos centres d'intérêt, Dagoma utilise des cookies. En continuant de naviguer sur le site, vous déclarez accepter leur utilisation. En savoir plus.
J'accepte

Approximate time: 10 minutes

Instructions for first use - Introduction

First steps

that's it, you've received your Magis.

Together, we will discover your printer and accompany you in an experience: 3D printing with Dagoma.

We have prepared 4 objects for you to print.

For all this initiation, you will need about 75g of PLA Chromatik. A 250g coil will therefore do the job.

In this box you found...

The essentials

With your Magis you will receive apart from the essential elements to launch your first impression.

The accessories

Of course, that's not all, here's a little kit to take care of your Magis.

Video

Preparation

Before starting, remove the 3 orange shims underneath the tray.

Place au montage

Video

Stage 1

The arms

Place the Neva in front of you, the button facing forward.

Place the head in the center of the printer.

Orient the fan towards the orange part on the rear side of the printer.

Connect the head to the carriages using the magnetic arms.

Video

Step 2

The calibration

Calibrate the machine according to the instructions in the illustration (perform the step each time you move the printer).

This step lasts 5 minutes during which your printer will sense the tray in different places.

Wait until it

Video

Step 3

Step 3

Take your coil and unwind some filament by hand.

Before each insertion, cut the filament so that the end is clean.

Place the filament in the extruder. Push it until it is driven by the machine for a few centimetres.

Then wait a few seconds, it gets hot.

It will suck up the rest of the filament by itself.

Make sure that the filament has reached the head.

First settings: CHECK!

  • Logo e-Nable France
  • Logo Lauréat Réseau Entreprendre
  • Logo Jeunes Entrepreneurs en France
  • Logo Great Place to Work
  • Logo Pass French Tech